Werbung
Verfügbare Sprachen
Verfügbare Sprachen
E08
E09
Speedometer
E10
E11
E12
Over-temperature protection.
Throttle failure.
Brake failure.
Headlight switch malfunction.
Communication failure.
It
is
usually
over-temperature
controller, due to continued travelling on slopes
or overload for a long time. The initial protection
will limit current output and will not generate
error code. If the temperature continues to rise,
it will trigger the alarm and cut the electricity.
It is because the throttle signal does not enter
the speedometer. The major reason is the one of
the three cables in connector has bad contact or
misplacement of the terminal. It might also be
due to non-wetting. You shall consider a
throttler or speedometer replacement.
The major reason is the bad contact between
brake and throttler or between brake and
speedometer, it is found the possibility of Hall
failure in throttler also. You shall adjust the
connector pin to ensure the connection or
replace the speedometer and throttler. In
normal case, the initial voltage signal is around
0.88V, after Hall throttler connects to 5V power
supply, or after vehicle turns on.
This error is not valid for the current model.
It is usually due to bad contact for main cable or
connector clips and open circuit. The easiest
way is to change a main cable. If it is not
workable, you shall check whether open circuit
with
the
15
Werbung
