Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
similarly qualified person in order to avoid a
hazard.
Transport damage
Your Poolrunner was packed carefully for the
transport.
Please ensure when taking over
that the packaging is in an undamaged condi-
tion and all parts are in the package. If you
have ordered the package by mail, make sure
that the delivery is complete. Transport dam-
age must immediately be reported to the car-
rier (transport company or parcel). The re-
sponsibility for damages during transit is the
transporter, the supplier is not responsible.
Warranty
Warranty in relation to operation safety and
reliability is only accepted from the manufac-
turer under the following conditions:
The pool cleaner is operated according
to the specifications of the user.
For repairs, only original spare parts
are used (wearing parts are not subject
to warranty).
Consequential damages
For damage to the product, caused by failure
to follow the manuel recommendations, we
can not
pay.
Position the power supply
The power supply of the device should be
appropriately positioned to allow the cleaner
to reach all corners of the basin.
avoid any accident/damage, the power supply
unit should be steadily placed and fixed at a
minimum distance of 3.5m from the pool
edge.
Specifications:
Input voltage: 230 VAC
Frequency: 50 Hz
Output voltage: DC (direct current) 24 V
Input power: 150 W
Output power: 120 W
Working cycle: 1 h. / 1,5 h. / 2 h. / 2,5 h.
Cable lenght: 12 m
Maximum cleaning area in the swimming pool: 100 ㎡
Filtering capacity: 15 m³/h
Filtering capablity: 150 μm
Working temperature (water):
Creeping speed: 15 - 18 m/min
Water resistance class: Cleaner: IPX8, power control box: IPX4
Ambient temperatur: 10°C - 40°C
Cleaner Structure, Figure 1
Connecting cable, Figure 2,3,4
Description of control panel, Figure 5
Item
1
2
3
Function of jet propulsion, Figure 6
Each on the front and on the back of the cleaner there are two ad-
justable control nozzles for the drive in the water. The sucked foul
water is first cleaned through the filter bag and then used for the
drive for the cleaner above the thrusters. The nozzles are adjustable,
depending on the size and pool type, to achieve the best cleaning ef-
In order to
fect.
Recommended nozzle settings:
High speed / less cleaning (with low pollution)
Slow speed / high cleaning efficiency (moderate to heavy contami-
nation)
The above are recommending settings and operator can select a
proper nozzle direction based on above principle actual pool situa-
tion.
Commissioning
Since you have made your settings, you can put the cleaner careful-
ly and slowly into the pool. Please refer to the following pictures as
the cleaner may be best placed in the pool.
The cleaner must always be committed or removed to the pool that
the underside of the cleaner facing the pool wall, to avoid possible
scratches on the pool surface.
IMPORTANT! Figure 19,20
Care and Maintenance
10°C - 32°C
Name
Function
ON/OFF
Power on or off
CYCLE
LED
Figure 11,12,13
Figure 17,18
Detail
Power on or
off
Stop after 1 hour
working, fit for small
swimming pool
Stop after 1.5 hour
working, fit for me-
dium
swimming
pool
Stop after 2 hour
working, fit for large
swimming pool
Flash
by
corres-
ponding cycle, all
indicators flash after
one cycle finish.
Figure 7,8,9,10
Figure 14,15,16
Werbung
