Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. MODEL IDENTIFICATION
Model and Serial numbers are the identification data for the machine. They are
shown on the drive mechanism guard flange (Point I, Fig.1).
4. MAINTENANCE - CLEANING - LUBRICATION
4.1 DRIVE MECHANISM OIL
Check oil leve with plug L fig.1
It is advisable to use AGIP ROTRA MP SAE 80W/90 oil.
First oil change, after the first 50-60 hours.
Change oil every 400 hours (plug L fig. 1);
quantity is about 0.450 Kg.
Oil discharge: plug M fig.1.
4.2 CUTTER BAR MAINTENANCE
Wash the bar after each use and then grease it with a light coat of oil.
If the machine is to be stored for a long time, first lubricate it throughout.
5 REGULATIONS
5.1 REGULATING PLAY BETWEEN KNIFE AND LEDGER
PLATE
See fig.4
The wear plates under the knife guide 3, must have a play of Y=0.2-0.3mm.
The guide block 4 must be mounted parallel to the rear sloped side of wear
plate 2.
Play between knife sections and knife guides should be X=0.2-1mm.
Alternating cutter movement should be possible by hand without meeting too
much resistance.
Follows these steps to register the play:
• X play: Slacken screws 5, register the guide block, re-tighten the screws.
• Y play: Slacken locknut 6, register play with screw 7, re-tighten locknut 6.
5.2 REGULATING PLAY BETWEEN KNIFE AND KNIFE GUIDE
(ESM BAR)
See fig.5
The knife sections 2, under knife guides 3, should have almost no play
whatsoever.
Mount guide block 4 parallel to the rear sloped side of the knife section 2.
Knife sections should protrude 0.5-2mm beyond the bar sections 1.
X play will vary between 0.1-1mm, and permit manual movement of the cutter
blade without meeting resistance.
24
Werbung
