Fujitsu ACFUSTBI Bedienungsanleitung Seite 17

OPERATING TIPS
The wired remote controller option is required to use the following function (**).
**Dual Remote Controllers (optional)
An additional remote controller can be added up to the maximum of 2 remote controllers. Either remote controller can control the air
conditioner. However, the timer functions cannot be used at the secondary unit.
**Group Control
1 remote controller can control up to 16 air conditioners. All of the air conditioners will be operated with the same settings.
Instructions relating to heating (*) are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).
AUTO Restart
In Event of Power Interruption
Sh o u l d th e p o we r sup p ly to th e ai r co n d iti on e r b e
l
interrupted by a power failure, the air conditioner will restart
automatically in the previously selected mode once the
power is restored.
Should a power failure occur during TIMER operation, the
l
timer will be reset and the unit will begin (or stop) operating
under the new timer setting. In this event, the TIMER
indicator lamp (orange) will flash.
Notices
* During use of the heating mode, the outdoor unit will
l
occasionally commence the defrost operation for brief
periods. During the defrosting operation, if the user sets
the indoor unit for heating again, the defrosting mode
will continue, and the heating operation will begin after
completion of defrosting, with the result that some time
may be required before warm air is emitted.
Use of other electrical appliances (electric shaver, etc.) or
l
nearby use of a wireless radio transmitter may cause the air
conditioner to malfunction. In this event, temporarily discon-
nect the power supply plug, reconnect it, and then use the
remote controller to resume operation.
* During use of the heating mode, the top of the indoor unit
l
may become warm, but this is due to the fact that cool-
ant is circulated through the indoor unit even when it is
stopped; it is not a malfunction.
En-17