Herunterladen Diese Seite drucken

Fujitsu ACFUSTBI Bedienungsanleitung Seite 11

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 19
ADJUSTING THE DIRECTION OF AIR CIRCULATION
Instructions relating to heating (*) are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).
Adjust the up, down, left and right air directions with the SET buttons on the remote controller.
l
Use the SET buttons after the indoor unit has started operating and the airflow-direction louvers have stopped moving.
l
Vertical Air Direction Adjustment
Press the SET button (Vertical).
Each time the button is pressed, the air direction range will change as follows:
1
Types of Airflow Direction Setting:
: During cooling/dry modes
1, 2, 3
: During heating mode*
1, 2, 3, 4, 5
The remote controller display does
not change.
Use the air direction adjustments within the ranges shown above.
l
The vertical airflow direction is set automatically as shown, in accordance with the type
l
of operation selected.
Horizontal flow 1
: During cooling/dry mode
Downward flow 5 : During heating mode*
During AUTO mode operation, for the first minute after beginning operation, airflow will
l
be horizontal 1; the air direction cannot be adjusted during this period.
Horizontal Air Direction Adjustment
Press the SET button (Horizontal).
Each time the button is pressed, the air direction range will change as follows:
1
The remote controller display does not change.
Use the air direction adjustments within the ranges shown above.
l
2
3
4
5
2
3
4
5
Right/left air direction louvers
1 2
3
4
5
Never place fingers or foreign objects inside
the outlet ports, since the internal fan operates
at high speed and could cause personal injury.
l
1
2
3
l
4
5
l
DANGER
Attempting to move up/down air direction
flaps or right/left air direction louvers
manually could result in improper
operation; in this case, stop operation
and restart. The louvers should begin to
operate properly again.
During use of the cooling and dry modes,
do not set the up/down air direction
flaps in the heating range (4 to 5) for
long periods of time, since water vapor
may condense near the outlet louvers
and drops of water may drip from the air
conditioner. During the cooling and dry
modes, if the airflow direction louvers
are left in the heating range for more
than 30 minutes, they will automatically
return to position 3.
When used in a room with infants,
children, elderly or sick persons, the air
direction and room temperature should
be considered carefully when making
settings.
En-11

Werbung

loading