Troubleshooting - SYMA X200 Bedienungsanleitung

5.0 Troubleshooting

Problem
Aircraft fails to take
off and the indicator
light keeps flashing
rapidly
Fly sideways when
hovering
Unstable hovering
Motor does not work
Remote control does
not work
Unable to pair the
drone with the remote
control
The aircraft vibrates
violently
15
Cause
1. The aircraft and the remote
control are not paired
2. The aircraft enters low
voltage protection
The drone is not level
calibrated
1. The drone is not level
calibrated
2. Unstable air pressure in bad
weather conditions
3. Cluttered gyroscope data due
to a violent collision
Check the motor for foreign
objects (eg: hair, sand)
1. Beyond the remote control
distance
2. Low battery of the remote
control
Check the battery of the
drone and remote control
Check whether the blade is
installed correctly or the
blade is damaged
Solution
1. Correctly pair the remote
control with the drone. The
indicator light will stay on
when the pairing is successful.
ccessful frequency bind.
2. The battery voltage of the is
too low, please fully charge the
battery
Re-do the level calibration, place
the aircraft on a horizontal
surface, and push both left and
right joysticks to the lower right
corner for about 3 seconds. The
indicator light on the aircraft
flashes quickly and then turns
solid, indicating that the
calibration is successful.
1. Re-do the level calibration,
place the drone on a
horizontal surface, and push
both the left and right
joysticks to the lower right
corner for about 3 seconds.
The indicator light on the
aircraft flashesquickly and
then turns solid indicating
that the calibration is
successful.
2. Try to avoid flying in a bad
weather and fly it in a
windless environment
3. Re-do the level calibration
and operate according to
point 1
Regular inspection and cleaning
1. Within the controllable flight
range
2. Replace the remote control
battery and install it with
correct polarity.
Charge the drone battery, or
replace the
battery of the remote control
with the correct installation
If the blade is deformed, replace
the blade
and install the clockwise and
counterclockwise blades
correctly.