SYMA X200 Bedienungsanleitung Seite 12

Level calibration
Place the drone on a flat surface and move the left and right joysticks to the lower right
corner for approximately 3 seconds. The indicator will flash rapidly and then turn solid,
which means that the calibration process is complete.
The drone cannot be calibrated if the angle of inclination is greater than 10 degrees.
Turning the drone on
1
2
Method one
Push the left joystick fully up
and return to the center.
Note:
!
1. If the drone is flying out of range from the remote control, the drone indicator light will
start flashing and the drone will land slowly.
2. If the remote control suddenly turns off or runs out of power during the flight, the drone
will automatically descend and come to a stop. To re-control the drone, the remote control
needs to be turned on again and the pairing also needs to be done.
9
Method two
Push the left and right joysticks
downward in a V shape for 2 seconds.
Method three
Press the one key
take off/landing button