Stihl RMA 239.1 Gebrauchsanleitung Seite 39

7 Assembling the Lawn Mower
6.5 LED on Charger
The LED indicates the operating status of the
charger.
If the LED glows green, the battery is being
charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.
7 Assembling the Lawn
Mower
7.1 Attaching the Handlebar
► Switch the lawn mower off and remove the
battery.
► Place the lawn mower on a level surface.
► Push bolt (1) through the bore in cable
guide (2).
► Fit upper handlebar (3) onto lower handle‐
bars (4).
► Attach cable guide (2) to cable (5).
► Push the bolt with cable guide (2) through
bore (6) from the inside to the outside.
► Push bolt (7) through bore (8) from the inside
to the outside.
► Place star grip nuts (9) on bolts (1 and 7) and
screw in.
0478-131-9629-B
► Install cable clip (10) on upper handlebar (3)
so the following condition is met:
– Distance (a) is between 25 cm and 27 cm.
► Place cable (5) into cable clip (10).
► Close tab (11) and allow it to engage.
The handlebar must not be dismantled again.
7.2 Folding Up and Folding the
Handlebar
7.2.1 Folding Up the Handlebar
► Switch the lawn mower off and remove the
battery.
► Place the lawn mower on a level surface.
► Fold up handlebar (1), ensuring that cable (2)
is not trapped.
► Firmly tighten star grip nuts (3).
Handlebar (1) is firmly attached to the lawn
mower.
7.2.2 Folding the Handlebar
The handlebar can be folded for space-saving
transport or storage.
► Switch the lawn mower off and remove the
battery.
► Place the lawn mower on a level surface.
English
39