Indoor Installation - Megasat Caravanman Kompakt Bedienungsanleitung

2. Installation

2.3 Indoor installation

1. The coaxial cable is laid in the interior of the vehicle.
2. Make sure when choosing a location for the control unit and the set-top box that both
devices are in a dry and protected place.
3. Do not place the control unit and the set-top box in a location near heat sources and
ensure sufficient ventilation.
4. Here are the basic connections for the antenna system:
• Connect the power supply (red and black cable) for the controller with your battery
of the vehicle via a fuse (7 amps) to avoid a cable fire at short circuit. The yellow ca-
ble is connected to the ignition plus of the vehicle, and also protected by a fuse of 7
amps (This cable must only be connected if the antenna is to automatically retract
when the engine starts). The remaining black cable is connected to the negative
pole of the associated ignition system (mass).
• Connect the cable coming from the antenna to the control unit:
- 10 m coax cable with f-connector to „ANTENNA"
• Connect the control unit to the set-top box:
- 1 m coax cable with f-connector from „RECEIVER" to set-top box
Note:
If you have the Caravanman Kompakt Twin, connect a second coaxial cable
from the antenna directly to the second set-top box.
ENGLISH
07