cecotec CONGA ETERNAL MAX TITANIUM Bedienungsanleitung Seite 59

The robot cannot charge or return to
the charging base.
The robot does not work properly.
The robot emits a strange noise
during cleaning.
The robot does not efficiently clean
or dust leaks from the robot.
The robot could not connect to the
Wi-Fi network.
The robot did not carry out the
scheduled cleaning task.
There are too many obstacles near the charging
base, relocate the charging base to an area free
of obstacles.
Clean the charging terminals on both the charging
base and the robot.
Make sure the robot vacuum cleaner is on.
The robot is too far away from the charging base,
place it closer and try again.
Turn off the robot vacuum cleaner and turn it on
again.
Reset the robot by pressing the reset side button.
The main brush, side brush or omnidirectional
wheel may be blocked or tangled, stop the robot
and clear them up.
The tank is full. Empty it and clear the high-
efficiency filter if it is blocked.
The high-efficiency filter is blocked, clear it.
The main brush is blocked or tangled. Please
clear it up.
Bad Wi-Fi signal. Check that the robot vacuum
cleaner is in an area with good Wi-Fi signal.
The Wi-Fi connection is unstable. Reset the
router, check if there are any App updates and try
again. This robot vacuum cleaner only supports
the 2.4GHz band.
Make sure that your device mobile data are
deactivated to improve the linking process.
Check if the robot vacuum cleaner is in night
mode and change mode. This option can be found
on the general settings of the robot vacuum
cleaner and allows you to define time slots in
which it will not perform the scheduled cleaning
tasks when it is on Night mode.
Make sure the robot vacuum cleaner is plugged
to the mains, that it will not be able to carry out
scheduled cleanings offline, and that the battery
is not low.
ENGLISH
ETERNAL MAX TITANIUM
59