Hama EWS-200 Bedienungsanleitung Seite 5

6. Operation
Note – Input
Hold down the UP button (23) or the DOWN/MEM button
(24) to select the values faster.
6.1. Connection to the measuring station
• After you insert the batteries, the base station automatically
searches for a connection to the measuring station and
performs initial setup.
Note
• Initial setup takes approx. 3 minutes.
• During connection, the wireless symbol on the measuring
station will ash (17).
• Do not press any buttons during setup. Otherwise, values
may not be transmitted correctly and there is a risk of
value errors and inaccuracies.
• The setup process is completed when the indoor (5, 16)
and outdoor (8, 18) measurement data is displayed.
6.2. Basic and manual settings
Automatic setting using the DCF signal
• After the rst time the base station is switched on and
successful transmission is established between the base
station and the measuring station, the clock will automatically
search for a DCF signal. During the search, the wireless
symbol (9) will ash.
• Following successful signal reception, the radio symbol
appears permanently and stops ashing.
Note – Time settings
• The search process takes about 7 minutes. If it fails, the
search ends.The radio symbol (9) disappears.
• In the meantime, however, you can set the time and the
date manually.
• The clock automatically continues to search for the DCF
signal on a daily basis (1:00, 2:00, 3:00, 4:00 and 5:00
a.m.). If the signal is received successfully, the manually
set time and date are overwritten.
Note
Language and time zone are preset to Germany. You can
nd instructions and information on making changes in our
detailed operating instructions at www.hama.com
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and
do not use aggressive cleaning agents. Make sure that water
does not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to observe
the operating instructions and/or safety notes.
9. Technical Data
Power supply
2 x AAA batteries
Measuring range 0°C – +50°C/ 32°F
Temperature
Humidity
Max. number of
measuring stations
Range
10. Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the
radio equipment type [00186310] is in compliance
with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet
address:
https://de.hama.com
Downloads.
Frequency band(s)
Maximum
radio-frequency
power transmitted
Base station Measuring station
3.0 V 3.0 V
2 x AAA batteries
-40°C – +60°C/
– 122°F -40°F – 140°F
20% – 95% 20% – 95%
3
30 m
00186310
433 MHz
4,932 mW
-
5