Hama EWS-Trio Bedienungsanleitung Seite 9

Note
• Do not press any buttons during setup. Otherwise,
values may not be transmitted correctly and there is a
risk of value errors and inaccuracies.
• The process is completed when the indoor (2/4) and
outdoor (5/6/7) measurement data is displayed.
6.2 Basic and manual settings
Automatic setting using the DCF signal (radio-
controlled clock)
• When the base station has been switched on for the rst
time and successful transmission has been established
between the base station and the measuring station, the
clock will automatically search for the DCF signal. During
the search, the radio symbol
Note – Time settings
• The search process takes about 3 - 7 minutes. If the
search fails, it ends and is repeated at the next clock
hour. The radio symbol ( ) goes out.
• It is not possible to manually set the time and date
during the search for the DCF signal.
• The clock automatically continues to search for the DCF
signal on a daily basis (between 1 am and 5 am) to
correct any deviations.
• If the signal is received successfully, the manually set
time and date are overwritten.
Note – Time zone
• The DCF signal can be received over long distances, but
always transmits the current Central European Time in
Germany. Please note that for countries with a different
time zone, you must set the time difference manually.
• If you are in Moscow, for example, the time is 3 hours
later than in Germany. This means that you should
set +3 for the time zone. The clock then sets the time
automatically to 3 hours ahead after receiving the DCF
signal or according to the manually set time.
6.3 Backlight
• Press the SNZ/LIGHT button (10) to light up the display
for approximately 5 seconds.
for DCF reception ashes.
7. Care and Maintenance
• Only clean this product with a slightly damp, lint-free cloth
and do not use aggressive cleaning agents.
• Make sure that water does not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
9. Technical Data
Power supply
3x AAA batteries
0°C – +50°C /
Measuring range:
32°F – +122°F
Temperature
Humidity
Measurement
increments:
Temperature
Humidity
Max. number of
measuring stations
Range
10. Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the
radio equipment type [00186311] is in compliance
with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet
address: www.hama.com -> 00186311 -> Downloads.
Frequency band(s)
Maximum radio-frequency power
transmitted
Base station Measuring station
4.5 V
2 x AA batteries
-40°C – +70°C /
-40°F – +158°F
10 – 99% 20% – 95%
0.1°C / 0.2°F 0.1°C / 0.2°F
1%
3
30 m
433 MHz
9,419 mW
3.0 V
1%
9