Herunterladen Inhalt Inhalt Diese Seite drucken

Removing Water From The Tank; Water Treatment; Slider Footplate; Adjusting The Footplate - Tunturi Pure Row 8.1 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Begin filling the tank by squeezing
the siphon. Use the level gauge decal
on the side of the tank to measure
volume of water in the tank.
After filling the tank to the desired
water level, open the valve on the top
of the siphon to allow excess water to
escape.
Ensure that the tank plug is replaced
once filling and water treatment
procedures are complete.

removing water from the tank

Set the resistance adjuster handle to
MIN.
Row at least ten strokes to fill the
inner storage reservoir as much as
possible with water.
Remove the tank plug.
Insert the siphon rigid hose end into
the tank
Insert the siphon flexible hose end
into a large bucket.
Drain the tank (approx. 40% of
water will remain in the tank. It is not
possbile to drain the tank completely
without disassembling the tank)
Refill the tank following the directions
as described under the section
"Filling the tank" of this manual.
NOTE
The valve on top of the siphon must
be closed to allow proper drainage.
If the water treatment schedule is
maintained, it will not be necessary
to change the water inside the tank.
An additional water treatment tablet
is only required when discoloration of
the water appears.
12
Exposure to sunlight affects the
water. Moving the rower away from
direct sunlight will extend time
between water treatments

Water treatment

Add one water treatment tablet (20)
Add a water treatment tablet
whenever the water appears dirty or
cloudy over time.
WARNING
Only use the Tunturi supplied water
treatment tablets.

Slider footplate

The slider footplate is designed to fit a
wide range of foot sizes.

Adjusting the footplate

Lift the top of the sliding portion of the
footplate and slide up or down. The
numbers 1-6 represent a guideline
from which the proper length can be
determined. Secure the plate onto the
mounting pegs and push down firmly to
lock into position.
Tighten the foot straps securely and
begin your workout.

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis