cecotec Cumbia POWER INSTANT-CCINO 20 Bedienungsanleitung Seite 22

ENGLISH
- Place a suitable cup under the milk tank spout.
- As soon as the device has heated up, the control panel will stop flashing. Press the milk
froth button (21), the machine will beep, and the selected button will flash.
- Once the coffee is ready, the machine will beep, the control panel will light up again and the
device will automatically switch to standby mode.
Note:
The device will remain in operation and the control panel will be lighted up for up to 30
minutes after the last operation. During this time, the cup warmer (15) keeps on heating. Once
30 minutes have elapsed, the device needs to be switched on again using the on/off button
(16) to prepare another coffee.
Note:
The coffee process can be stopped at any moment by pressing the selected coffee
button again. This will switch the device to standby mode.
Coffee customisation
The coffee machine includes a customisation function which allows selecting the exact
amount of coffee and milk for each coffee, saving the desired settings for future uses. The set
quantities are saved until a new quantity is set.
Espresso, double espresso, and milk froth
- Depending on the beverage to be prepared, fill the tank with water or milk as explained in
the previous section.
- Long press the selected coffee button (2 beeps) until you have the desired amount of
coffee or milk.
- Only stop pressing the button when there is enough coffee or milk in the cup. Once you stop
pressing, the coffee machine will beep 3 times indicating that the quantity has been saved.
Cappuccino and Latte Macchiato
In order to prepare these coffees, the process has to be repeated twice, once for the quantity of
espresso and once for the quantity of milk.
- Fill up the milk or water tank. Make sure the milk tank spout (8) is folded out and that there
is a cup under the milk tank spout.
- Select the desired amount of milk: long press the selected coffee button (1 beep) and let go
once you have enough milk.
- Select the desired amount of coffee: long press the same selected coffee button (1 beep)
and let go once you have enough coffee.
- Once you stop pressing, the coffee machine will beep 3 times indicating that the quantity
has been saved.
42 POWER INSTANT-CCINO 20
Setting the milk froth quantity
Use the knob on the milk tank's side to select more or less milk froth. Turn the knob clockwise
for more froth and anticlockwise for less froth.
Resetting to factory settings
- In order to delete the coffee and milk amounts set previously and restore factory settings:
- Press the on/off button (16) to switch the device off.
- Press buttons (24) and (17) simultaneously and keep them held down.
- Press the on/off button (16) to switch the device on again. The control panel will flash 5
limes and the coffee machine will beep 5 times.
- Stop pressing the button. The amounts have now been reset to the factory settings.
4. CLEANING AND MAINTENANCE
- Clean the milk tank (9) and the filters after every use with mild detergent and hot water or
in the dishwasher.
- Rinse through the tube in the milk tank with clear hot water to remove milk residues after
every use.
- If necessary, clean the water tank (2), the drip tray (10), and the grille (11) with mild
detergent and hot water or in the dishwasher.
- Perform the cleaning cycle (see "Auto-clean" section) to clean the water tank system as
well as the coffee spout (14) or the portafilter (12).
- Wipe down the housing with a damp cloth. If necessary, use a little mild detergent to
remove more intense soiling.
- Thoroughly dry the device and all accessories before assembling it again.
- Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to clean
the device, these can damage the surface.
Auto-clean
Quick cleaning of the milk tank system:
- Fill the milk tank with water.
- Fold out the milk tank spout (8) using the lever (7).
- Press the on/off button to (16) turn the device on and preheat water. During the preheating
process, the control panel will flash.
- Place a suitable cup under the milk tank spout.
- As soon as the device has heated up, the control panel will stop flashing. Press the button
(20): the coffee machine will beep, indicating that the auto-clean cycle has started.
- Once the cycle is over, pour away all the cleaning rests.
- Repeat this process if necessary.
ENGLISH
POWER INSTANT-CCINO 20 43