Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Electrical System Safety
For safety reasons, the machine is
equipped with double insulation and
does not require an earth connection.
The operating voltage is 230 V AC, 50
Hz (for countries outside the European
Union 220 V, 240 V depending on the
version). Use only an approved
extension cord.
For greater safety, it is recommended
to use a differential circuit breaker with
a fault current
30mA maximum. Before each use of
the appliance, check this differential
circuit breaker.
Device connection cable
Only use connecting cables for the
device that are not damaged. The
connection cable of the device must not
be too long (max. 50 m), otherwise the
power will be reduced.
of the electric motor. The cross-section
of the device connection cable must be
3x 1.5mm2. Connection cables often
suffer from damage to their insulation.
The causes are among others:
- cracks due to aging of the insulation
- bends due to incorrect attachment or
routing of the connecting cable If such
connecting cables are used then
if their insulation is damaged, they pose
a life-threatening hazard. Cables, plugs
and couplings must meet the conditions
in the following list. The connection
cables of the devices must have rubber
insulation.
The connection cables must at least be
of the H05RN-F type and have 3
strands. A printout of the type
designation on the connecting cable is
mandatory. Only buy properly marked
connection cables! The plugs and
coupling sockets to the connection
cables must be made of rubber and be
protected against splashing water. The
connecting cables of the devices must
not be too long. Long connection
cables must have a larger conductor
cross section.
Connecting cables and connecting
lines must be checked regularly for
damage. Make sure that the cables are
disconnected during the check.
Completely unwind the connection
cable from the device. Also check the
insertions of the connection cables, at
the level of the plugs and coupling
sockets, for any kinks.
The device is suitable for private use in
domestic and hobby gardens.
Observance of the instructions for use
enclosed by the manufacturer is the
essential prerequisite for proper use of
the device. The user manual also
includes service, maintenance and
servicing conditions.
For safety reasons, the device must not
be used as a training module for other
work tools and tools of any form
whatsoever.
For your safety
v Follow the safety instructions for the
electric hoe.
59
Werbung
