ecofort ecodry CaveMaster Installationsanweisungen Seite 26

Step 7: Lead the water hose into the opening
on top of the pump.
Step 8: Fix the drainage connector in the
hole on the bottom of the dehumidifier
with the provided screws and plug in the
pre-installed smaller water hose inside the
dehumidifier.
Step 9: Repeat steps 1 through 3 in reverse, screwing in all 16 screws,
placing back in the filter and water tank. Plug in the long water hose to
the drainage connector and lead the hose to an appropriate place where
the water can be drained.
Note: In pump mode, the water tank must be installed in place as well,
or the display will show "F" and dehumidifying will not work.
Step 10: Press and hold the "Humidity Setting" button while plugging in the
dehumidifier to a power outlet. "P" is shown on the display, meaning the pump
function has been successfully activated. Press the power button in order to
start dehumidifying. The installation is now complete.
Steps 1-8 are shown in video 1:
Step 10 is shown in video 2:
26