ecofort ecodry CaveMaster Installationsanweisungen Seite 25

Installation Guide
In order to install the pump in your ecodry CaveMaster, please follow these
steps:
Step 1: Remove black screws (6 on top, 8 on each side of the device)
Step 2: Remove cover and the filter grill with the air filter. Lift cover and unplug
the connection to the printed circuit board of the unit's control panel. Then lift
off the cover completely.
Step 3: Remove 2 black screws at the front bottom of the device.
Step 4: Cut the cable tie fixing the two cables on the bottom front of the device.
Step 5: Install the pump in the front of the device; cables should be pointing to
the right, water hose facing the left. Plug in cables; black plug on black plug,
white plug on white plug. Align the two holes in the front rail foot of the pump
with the two brackets on the bottom of the dehumidifier and screw in the two
provided screws to fix the pump unit permanently (the pump's rail foot facing
you with the brackets behind).
Step 6: Remove water tank and install the short water hose with the larger
diameter by leading it through the opening and plugging it onto the water outlet
of the dehumidifier. Fix the hose with a cable tie and remove the excess with a
side cutter.
25