Beurer EC 70 SafePlus Gebrauchsanweisung Seite 40

NOTICE
Despite careful development and testing, certain events may not trigger an emergency
notification. This may be because the impact was too weak and was not detected as
a fall. There may be falls where the wristband's sensors cannot detect the necessary
parameters. Examples include gently sliding down to the floor against a wall or from
a chair without a hard impact. Although the wearer may perceive this as a fall, it can-
not be detected by the device. To minimise unnecessary false alarms, the fall detection
function has been optimised so that dropping the device does not normally trigger an
emergency notification. The fall detection function is being continuously improved and
is automatically updated the next time the device is charged and an update is available
and pending.
If you have also booked the professional emergency call service, the
emergency notification will also be forwarded to a 24-hour emergency call
centre. This establishes a voice connection with the wearer and takes the
necessary measures to provide assistance as quickly as possible. In the
app, you can select whether the emergency call service should accept
immediately or only when all emergency contacts have declined.
7.8 Cancelling (false alarm) / ending the emergency mode
If there is a false alarm or if the emergency call has been ended successfully, you can
cancel/end the emergency mode (regardless of whether the emergency notification was
triggered manually or automatically).
• To cancel the emergency notification within the 20-second emergency sequence,
press and hold the ON/OFF/emergency button
then stop flashing and the emergency alarm and vibration will stop. No emergency
notification will be sent to the emergency contacts.
• To cancel the emergency notification after the 20-second emergency sequence or
after a successful emergency call, proceed as follows:
Press and hold the ON/OFF/emergency button
then go out.
You have successfully cancelled the emergency call and the emergency mode has
been ended.
The wristband is now back in its original state. We recommend charging the wrist-
band after an emergency notification has been triggered.
for 3 seconds. The LEDs
3
for 3 seconds; the 4 LEDs will
3
40
will
2