Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.7 Fall detection/manual emergency notifications
1. a) An emergency notification is automatically triggered when
the smart fall detection function senses that the wristband
wearer has fallen.
b) To manually send an emergency notification, press and
hold the ON/OFF/emergency button
3 seconds.
2. The LEDs
2
flashing pattern one after the other. An emergency alarm also
sounds via the built-in loudspeakers and the device vibrates.
This emergency sequence lasts 20 seconds and can be can-
celled at any time until the notification is sent. If the emergency
sequence is cancelled, a call cannot be made.
3. The emergency wristband will now try to connect to the serv-
er and send an emergency notification. This is indicated by a
yellow running light. The duration of this process depends on
the network connection at the location in question and can
take several minutes.
4. After the emergency notification has been successfully sent, the
LEDs
show a green running light. The emergency contacts
2
are now informed of the emergency via the app.
5. As soon as the emergency contact makes a voice call and is
successfully transferred, the wearer does not need to take any
further action to accept the call. The LEDs light up steady green
as soon as an active voice connection is established. The wear-
er can now communicate with the emergency contact via mi-
crophone
4
then start to flash red and change to a yellow
and loudspeaker
for more than
3
.
1
39
Flashing red
Flashing yellow
Yellow running
light
Green running
light
Green light
Werbung
