Use; Advises For Use; Safety Features - Spring 58 9842 03 31 Gebrauchsanweisung

6.2

Use

- Insert the power cord into the device and connect up to 4 further devices.
- Plug the power cord into a suitable socket according to chapter 14 Technical specifications.
- Place suitable cookware on the glass ceramic surface. The circular markings are for your orientation, to
activate the pan detection.
- It is possible to operate several appliances, which are in the radio range, at the same time with the remote
control. Make sure that the devices will not inadvertently be switched on or off. To operate one appliance only,
hold the wireless remote control close to the corresponding induction unit.
- Press the button
10 seconds press the
level P. The selected temperature will appear in the display. Afterwards the current temperature will be shown
in the display.
- When you set to level P, the appliance will start heating continuously for 30 minutes and afterwards return to
95 °C automatically. You can reduce manually the temperature. Only after 20 minutes, it can be selected
again. Caution: Pay special attention while heating fat and oil at this level to avoid overheating.
- After use, switch off the appliance by pressing the button
Remove the cookware from the glass ceramic surface. If necessary, use heat-resistant gloves and place the
cookware only on surfaces that are not sensitive to heat.
- Always pull out the power cord and allow the appliance to cool down completely after each use.
6.2.1

Advises for use

- Only place the cookware/serving dish on the glass ceramic surface carefully. Do not slide it, instead lift it up
and set it down in the desired position. Make sure that you do not slide e.g. a casserole when portioning and
taking out the food. This will prevent scratching and potential damage to the surface.
- Make sure that the cookware/serving dish rests securely on the induction unit and does not protrude over the
side of the glass ceramic surface.
- In order to keep food warm reliably, heat up the empty serving dish before filling it and cover it with a matching
lid.
- Stir the dish as necessary in order to keep it consistently warm.
- In order to avoid burning food residue and difficult cleaning thereafter, do not leave the empty cookware on
the appliance with it switched on.
- Remove spills from the glass ceramic surface immediately in order to avoid burning them onto the surface.
6.3

Safety features

Automatic switch-off
If you do not select any temperature within 10 seconds after the appliance was switched on, the induction unit
will switch off automatically.
Pan detection
If the built-in induction unit cannot detect any appropriate cookware, it will switch off automatically.
Double overheating protection
If the cookware overheats e.g. when it is heated while empty, or while the surrounding temperature is too high,
the appliance switches off automatically.
on the control panel or on the remote control to switch on the appliance. Within


button resp. button to set the temperature between 60 – 95 °C or to select
on the control panel or on the remote control.
23