Werbung
Verfügbare Sprachen
Verfügbare Sprachen
● The mount holder should be installed on a flat surface of the dashboard otherwise the installation may not be secure.
● Take care to ensure that the mounting location does not impair the visibility of the driver.
● Rotate the rotary knob clockwise to tighten the monitor to the mount holder.
● Loosen the rotary knob on the rear of the monitor to adjust to the desired angle then retighten the rotary knob to lock the monitor.
● Do not remove the mount holder once it is attached as the adhesive may lose its adhesion capability.
● If necessary, the monitor may be removed by unscrewing the rotary screw on the rear of the monitor.
2. Attach the antenna to the monitor.
3. Connect the monitor cable with the car charger cable. Plug the car charger into the cigarette lighter port in your car.
Note:
In order to ensure good electrical contact confirm that the monitor cable is fully inserted into the car charger cable, leaving no gap.
Note:
● If the power outlet socket of the vehicle is permanently powered(i.e. powered after the engine/ignition is turned off), the charger should be
removed from the power source before leaving the vehicle in order to prevent draining the vehicle battery.
● If the signal is weak, please use an extension antenna to strengthen the signal.
Install the Backup Camera
Note:
This product supports two cameras. The kit contains one camera. If you require a second camera, please ensure that you purchase a
camera of the same specification as the one supplied.
①
②
5
③
Werbung
