Werbung
Verfügbare Sprachen
Verfügbare Sprachen
① Reason: The monitor or the car charger is broken.
Solution: A. Plug the car charger in the cigarette lighter. If the red light on the car charger doesn't light up which indicates the car
charger is broken, please contact us to replace the car charger.
B. Power the monitor, if the red light on (OK) is always on which indicates the monitor is broken, please replace the monitor;
if the red light doesn't light up, please check if the connection between the monitor cable and car charger cable is poor
contact, if the connection is good which indicates the car charger is broken, please contact us to replace the car charger.
② Reason: The monitor is not connected with the rearview camera.
Solution: When press the button on the car charger, the indicator light of (OK) on the display flashes twice, but the display does not
show image. And no image shows when press any buttons on the monitor, it may be caused by the signal disconnection
between the monitorand the camera. Please troubleshoot as following steps:
A. Turn on the backup camera.
The camera power may be off. Press the power button on the camera to turn on the camera.
B. Charge the backup camera.
The camera may be low on power, please charge the camera.
C. Re-pair the monitor with the camera. Please follow the steps:
1) Press (M) to enter the Menu setting, select "Pair".
2) Select Cam1/Cam2, press the (M)/(OK) to enter into the selected channel pairing interface, and the indicator lights of
(OK) will flash fast.
3) Long press the button on the camera for 8 seconds until its blue indicator light flashes, and the pairing will proceed
automatically. If paired successfully, the screen will automatically display rear view image, and the blue indicator on
the camera will remain on.
Note:
● Please turn the camera on after completing the step 1-2, or the pair will fail.
● The pairing timeout is the default 30s. If the pairing does not finish in 30s, the pairing screen will close automatically, then the monitor enters
standby mode, please follow the steps to pair the camera again.
14
Werbung
