Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4) Press (▲) or (▼) to choose from 6 different sizes. Press (M)/(OK) to confirm.
Note:
The setting screen will close automatically if no operation is performed for about 5 seconds, then the settings will be saved.
2. Pair the Camera
Cam1 uses CH1 channel by default and is paired before leaving the factory, no need to pair again.
If you need to re-paire/change the camera or install the Cam2, please follow the steps:
1) Press (M) to enter the menu setting, select "Pair".
2) Select Cam1/Cam2, press the (M)/(OK) to enter into the selected channel pairing interface, and the indicator light of (OK) will flash fast.
3) Long press the button on camera for 8 seconds until its blue indicator light flashes, and the pairing will proceed automatically. If paired
successfully, the screen will automatically display rear view image, and the blue indicator on the camera will be on continuously.
Note:
● Please turn the camera on after completing the step 1-2, or the pairing will fail.
● The pairing timeout is the default 30 seconds. If the pairing is not completed in 30 seconds, the pairing screen will close automatically and
the monitor will enter standby mode. Follow the steps to pair the camera again. If the pairing fails after several attempts, please contact
Customer Support for assistance.(Customer support email: service@auto-vox.com)
3. Switch Between Cam1/Cam2 Channel or Split Screen
If the monitor has been paired with Cam1&Cam2, and the monitor is not on any setting interface, press (CH) to switch between Cam1 display,
Cam2 display and split screen.
Note:
● The monitor will show the full image of the CH1 channel as a priority when both cameras are powered.
● Contrast, M/U Control, Guidelines and Reset can be changed separately by channels. For example, if the Guidelines for Cam1 are changed
on CH1 or the split screen, they will only be saved in the current channel, not in both channels.
Brightness will however be saved on both channels if it is changed.
10
Werbung
