Werbung
Verfügbare Sprachen
Verfügbare Sprachen
P
re-installation Note
1. Please follow the manual to install the product, and do not impair the equipment, control units and systems inside the vehicle. Follow local
applicable laws and safety regulations for vehicles!
2. Park on an even and safe location and then install the product.
3. Before installing the backup camera on your vehicle, please must test the product following the steps. If there is no problem after the test,
charge the camera and prepare for installation.
a. Supply power to the monitor. If the indicator light of (OK) flashes once and the monitor displays the power logo, the monitor is on and
functioning.
b. Press the power button to turn on the rear camera.
c. When the monitor connects with the rear camera and displays the image, the blue indicator light on the rear camera will always be on.
d. When the screen turns off, you can press the button on the car charger or the monitor to activate the system. If there is no image on the
monitor, refer to the troubleshooting section.
Charge the Backup Camera
Charge your camera before you install it on your vehicle. It takes 6.5 hours to fully charge. When the camera is charged, the red indicator light
is lit. After fully charged, the red indicator light is not on.
Note:
Please use a standard USB charger with a rated output of 2000mA or higher.
OUTPUT：5V≥2A
Jump starter
3
Micro USB plug
Charging
Fully charged
Werbung
