Werbung
Verfügbare Sprachen
Verfügbare Sprachen
③ Reason: The signal reception of the monitor is weak.
Solution: The monitor has a weak signal. It is recommended to change the location of monitor or use an
extension antenna for help.
If it is still no image showing after above tempts, please contact customer support for help.
(Email: service@auto-vox.com)
Q2. The image shakes when you are driving the car.
Reason: The camera mounting screws may be loose.
Solution: Check the the condition of the screws, and tighten the screws according to the situation.
You can scan the QR code to watch the detailed troubleshooting video on YouTube.
Note:
C
are and Maintenance
For maintaining its condition and performance, please follow the guidelines below.
1. Power off the monitor and unplug the car charger before cleaning the monitor.
2. Clean the backup camera kit with a soft, dry cloth only.
● Do not use any liquids or harsh cleaners as these may cause discoloration and/or damage to the surface of the equipment.
● Do not immerse or allow liquids to enter the equipment.
● Only operate the backup camera when the equipment is dry.
3. Always store the backup camera system in a dry, dust-free environment as moisture may damage the electronics.
4. Avoid storage under extreme temperature fluctuations as condensation, possibly generated under these conditions, could damage the electronics.
5. Check the camera and monitor fasteners periodically to ensure they are secure and tightened, if necessary.
Note:
Before cleaning the monitor, please make sure to cut off the car charging source. Never use solvents such as benzene, thinner or cleaners
available commercially to clean the system.
15
Werbung
