Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Note:
1. If the camera is not used for more than two weeks, press the power button on the bottom of the
camera to turn off the camera(As shown right). This can extend the life of the camera.
2. The fully charged the camera can work continuously without the solar panel for about 15 hours in day
mode and 7.5 hours in night mode. If the backup camera is used 3 times per day for 120 seconds per
time then a fully charged camera can last about 3 months.
When a low battery icon appears on the monitor, charge the camera promptly to maintain functionality.
(Operating times are for reference only and actual times depend on individual operating conditions.)
Tip:
By default, the monitor will stop displaying and go into standby mode after 240 seconds.
3. If you use a power bank to charge the device, make sure that its battery capacity is no less than
6600mAh.
4. The camera may be charged while installed in the vehicle using the USB cable or you may remove it
for charging by following these instructions:
① Unscrew the anti-theft screw of the camera with the supplied screwdriver.
② Remove the camera from the camera bracket base. Hold the camera. Slide the camera towards the
anti-theft screw hole until it disconnects from the camera bracket base.
I
nstallation
Install the Monitor
1. Clean and dry the area of the dashboard where you would like to mount your monitor. Tear off the sticker from the base of the mount holder
and stick it to the dashboard. Press the base against the mounting surface for 15 seconds and let it stand for 2 hours to ensure the sticker
adheres firmly.
4
①
②
Werbung
