Operation - Beurer FC 72 Gebrauchsanweisung

• Adjust the angle of the nozzle to the required height.
Important
Do not adjust the nozzle when the device is in use! You could
sustain burn injuries to the hand.
• Wash your face with a damp cloth before using the device.

7. Operation

Do not use the ionic facial sauna for more than 15 minutes per day. It is recommended that two to
three treatments are performed per week.
After you have made the necessary preparations described in "Section 6. Initial use", you may start
the treatment.
To start the treatment, carry out the following steps:
• Connect the mains plug to the socket and press the ON/OFF button.
The indicator lamp illuminates blue. The device starts to heat the
distilled water. After approximately 1 minutes, steam begins to flow
from the nozzle. After approximately 1-2 minutes, the steam is strong
enough and you can begin the treatment.
• Move your face slowly towards the flow of steam so that the steam
covers your entire face. The steam should feel pleasant and not too
hot. If you feel the steam is too hot, move further away from the
nozzle to prevent burn injuries.
Warning
Ensure that your face does not get closer than 25 cm to the nozzle.
Otherwise there is a danger of your facial skin becoming red or
sustaining burn injuries.
The device shuts off automatically if there is no water left in the device or after 15 minutes.
• Remove the mains plug from the socket.
• After the treatment, wash your face with cold water. Now apply a facial cream or face mask. The
open pores allow the active agents to penetrate deep into the skin.
• Allow the device to cool down for 10 minutes. Afterwards, clean the device as described in
Section "8. Cleaning".
12