ATIKA T 250 N Originalbetriebsanleitung, Sicherheitshinweise Und Ersatzteile Seite 24

Fault
Chip outlet is clogged
Motor running, saw blade will not
turn.
Saw vibrates
Type / Model
Year of constructions
Motor output P
1
Mains voltage
Mains frequency
Saw blade speed
Mains fuse
Hard metal saw blade Ø maximum
Hard metal saw blade Ø minimum
Saw blade thickness
Cut width
Number of teeth
Thickness of splitting wedge
Saw blade location hole
Cutting speed (at maximum saw blade Ø)
Cutting height at 90° (for maximum saw blade Ø)
Cutting height at 45° (for maximum saw blade Ø)
Bevel cut adjustment
Table size (with length and width extension)
Table height (with stand)
Table length extension
Table width extension
Weight (with stand)
exhaust outlet saw guard Ø
Exhaust connection Ø
Commercial small dust removers or industrial vacuum cleaners can be used for exhaustion.
22
Possible cause
• No exhaust system connected
• Exhaust power too weak
• V-belt too loose or defect
• Saw blade is warped
• Saw blade not properly mounted
T e c h
T e c h
Removal
• Switch off saw, remove chips and connect
exhaust system
• Switch off saw, remove chips and increase
exhaust power (air velocity 20 m/sec at chip
exhaust neck).
• Contact an authorised customer service
workshop
• Replace saw blade
• Mount saw blade properly
n i c a l d a t a
n i c a l d a t a
RTS250-IA / T 250 N
see last page
1800 W (S6 - 40%)
230 V~
50 Hz
5700 min
-1
16 A inert
250 mm
245 mm
1.6 mm
2.4 mm
24
2 mm
30 mm
75 /
m
s
ca. 0 - 73 mm
ca. 54 mm
0° – 45°
935 x 944 mm
860 mm
325 x 440 mm
550 x 250 mm
ca. 28.0 kg
35 mm
35 mm