ATIKA T 250 N Originalbetriebsanleitung, Sicherheitshinweise Und Ersatzteile Seite 22

M a i n t e n
M a i n t e n
Before each maintenance and cleaning
work
− switch off device
− wait for stop of chain saw
− pull out main plug
Further maintenance and cleaning works than described in this
chapter shall only be carried out by the manufacturer or
companies named by the manufacturer.
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected
damages and injuries.
Maintenance
Changing the saw blade
Before replacing the saw blade:
− switch off device
− wait for stop of chain saw
pull out main plug
−
Do not use any saw blades made of HSS steel.
Do not use any cracked saw blades or such that have
changed their shape.
Only use well-sharpened saw blades
Danger of cutting! Wear gloves when replacing the saw
blade.
Use only suitable saw blades.
Danger of burning! The saw blade is still hot shortly
after cutting.
Bring the saw blade to the highest position.
Remove the safety guard (5).
Remove the table section (27).
Position the ring wrench (29) on the hexagon nut (30)
and the installation wrench (28) on the motor shaft end and
loosen the hexagon nut (30).
Wear safety gloves.
Remove the hex nut (30) and the saw blade flange
(31). Pull the saw blade (19) off.
Clean the flange.
Fit the new saw blade in reverse order.
Note the direction in which the saw blade turns (see arrow
on saw blade).
Finally, fit the safety guard again.
The saw blade must be in the highest position.
Comply with the stated dimensions.
Tighten the nut (30).
20
a n c e a n d C a r e
a n c e a n d C a r e
Replacing a table section
Replace any worn or damaged table section without any
delay.
Cleaning
Observe the following to maintain the functionality of the
saw.
Do not wash down device with water.
Remove splints and sawdust only with a brush or vacuum
cleaner.
Clean and oil all moving parts regularly.
Never use any grease!
Use for instance sewing machine oil, liquid hydraulic
fluid or environmentally acceptable spray oil.
Take care that the saw blade remains free of rust and resin.
Remove all resin residues from the saw bench top
Resin residues can be removed with a commercial
maintenance and care spray.
The saw blade is a wearing part and will become dull after
prolonged or frequent use.
renew the saw blade or have it sharpened
T r
T
Remove mains plug before each
transport.
The saw must only be transported with the saw blade
lowered and the protective cover in position.
This will avoid possible injury from the saw blade.
S
S
Remove the mains plug from the socket.
Store unused equipment in a dry, locked place out of the
reach of children.
To extend the service life of the saw and guarantee smooth
operation, before storing for a longer period
− thoroughly clean the saw
− treat all movable parts with an environmentally friendly
oil
Never use any grease!
To save storage space, the saw frame can be collapsed.
G
G
Please observe the enclosed terms of guarantee.
a n s p o r t
r a n s p o r t
t o r a g e
t o r a g e
u a r a n t e e
u a r a n t e e