ATIKA T 250 N Originalbetriebsanleitung, Sicherheitshinweise Und Ersatzteile Seite 21

Make sure that the fences are correctly adjusted. ( See "
Working instructions").
Setting the longitudinal stop
1. Place the longitudinal stop in the guide profile on the bench.
2. Set the desired dimension and turn the lever (8) down.
3. To obtain a precise cut, first make a test cut and then
readjust the stop as needed.
W o r k i n g
W o r k i n
Before starting to work consider the following safety advices to
keep the risk of injuries as small as possible.
Protective guard, splitting wedge and saw blade ok?
Place your hands flat on the workpiece with fingers closed.
Stoppers (fences) ready for use and pushstick to hand?
Workplace tidied?
You may not start to operate the machine until you have
read these operating instructions, observed all the
instructions given and installed the machine as described!
Before making adjustments to the saw settings (e.g. replacing
the saw blade etc.)
− switch off device
− Wait for standstill of the saw blade
− pull out main plug
Also, note the following important points:
Place yourself outside of the area of danger.
Place your hands flat on the workpiece with fingers closed.
With it, lead the work piece with the hand only up to the
leading edge of the saw blade protection.
Never remove loose splinters, chips, or similar by hand.
Observe all safety instructions in any case.
w i t h t h e s a w
g w i t h t h e s a w
Cutting narrow workpieces
(Width less than 120 mm)
Push the workpiece forward with both hands, in the area
of the saw blade, use the pushstick (24).
When working on very flat and narrow workpieces
(Width 30 mm and less) use the lower guide are of the
fence (6A).
Cutting wide workpieces
With the flat of the hand and the fingers closed, push the
work piece to be cut along the stop.
Cross cuts / mitre cuts
Push the transverse stop (3) into one of the guide grooves
on the table and set the transverse stop to the required
angle.
Push the longitudinal stop (6) into the required position, so
that the work piece can be securely held in place.
Place the workpiece to be cut against the stop rails.
Hold the workpiece firmly in place and push it past the saw
blade using the transverse stop. Use the pushing bar if
necessary.
19