ATIKA T 250 N Originalbetriebsanleitung, Sicherheitshinweise Und Ersatzteile Seite 20

Splitting wedge setting
The splitting wedge is an important safety device as it prevents
the workpiece from recoiling
Always use the supplied riving knife.
To ensure the riving knife's proper function its distance
to the teeth of the saw blade must not exceed 3-5 mm
above the table.
Adjust the saw blade to its highest position.
Remove the safety guard (5).
Remove the table section (27).
Slightly loosen the hexagon screw (35) and correctly
adjust the riving knife. The riving knife must be in line with
the saw blade.
Tighten the hexagon screw using the ring wrench (29).
Set the cutting height
The cut height can
be adjusted stepless
from 0 - 73 mm using
the crank (11).
Before setting the cut
height, tighten the
set screw for the saw
blade (9).
Set the cutting height
5 mm higher than the
material thickness.
Adjust saw blade pitch
The saw blade must not be set to the inclined position
when the blade is turning. The motor must be switched
off first.
Adjusting between 0° - 45°
1. Loosen the clamping
screw (9).
2. Turn the handwheel until
the required angle is
shown (0° - 45°).
3. Retighten the set screw.
18
Adjusting the angle indicator:
1. Turn the machine off and unplug the power cord.
2. Use an angle stop to align the saw blade vertically.
3. Loosen the screw (A) and slide the angle indicator to the 0°
mark.
Fitting and adjusting the transverse stop
The transverse stop supplied can be used as a
transverse or mitre stop.
Setting the angle. Loosen the clamping screw of the
transverse stop by turning.
Fit the transverse stop to the saw table plate
Push the transverse stop into one of the two grooves
on the saw table plate.
Setting the angle
Loosen the clamping screw of the transverse stop by
turning. You can now set the stop to the required angle.
Turn the clamping screw tight again.
Fitting and adjusting the longitudinal stop
Fit the longitudinal stop to the saw table plate.
The longitudinal stop (6) can be installed on the left or right of
the saw blade. To attach the fence (6A) on the other side of the
stop,
remove the fence,
unscrew the two knurled nuts,
attach the guide plate on the other side of the stop,
reinstall the fence.