hexagon DIALTRONIC EASY Bedienungsanleitung Seite 8

4. Favorite key
E
The «Favorite» key gives direct access to a predefined function, and can be configured according to the needs of the
user. In order to assign a function to the «Favorite» key, give a prolonged press on
function :
Data transmission
(default)
Validation of selection: By a prolonged press on
Note : a function can also be assigned via RS232 using the command <FCT + Function No.> (FCT 0...3)
example : Hold display = <FCT1>
5. Switching off
The dial gauge goes automatically into stand-by if not used for 10 minutes.
Stand-by mode can be forced by a prolonged press (> 2 sec) on
In stand-by mode, the value of the origin is retained by the sensor, and the instrument automatically restarts with any
movement of the measurement probe, RS command or press a button.
Hold display
, or a short press on
:
8
, and then select the required
Zero reset
or
>2s
No function