Makita GA7020 Betriebsanleitung Seite 7

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Applicable grinding wheel
Applicable cut-off wheel
Applicable wire wheel brush
Spindle thread
Max. spindle length
No load speed (n ) / Rated speed (n)
0
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s). The lightest and heaviest combinations, according to
EPTA-Procedure 01/2014, are shown in the table.
Symbols
The followings show the symbols which may be used for the equip-
ment. Be sure that you understand their meaning before use.
Read instruction manual.
Wear safety glasses.
Always operate with two hands.
Do not use the wheel guard for cut-off
operations.
DOUBLE INSULATION
Only for EU countries
Due to the presence of hazardous compo-
nents in the equipment, used electrical and
electronic equipment may have a negative
impact on the environment and human health.
Do not dispose of electrical and electronic
appliances with household waste!
In accordance with the European Directive on
waste electrical and electronic equipment and
its adaptation to national law, used electrical and
electronic equipment should be collected sepa-
rately and delivered to a separate collection point
for municipal waste, operating in accordance with
the environmental protection regulations.
This is indicated by the symbol of the crossed-
out wheeled bin placed on the equipment.
Max. wheel diameter
Max. wheel thickness
Max. wheel diameter
Max. wheel thickness
Max. wheel diameter
Max. wheel thickness
GA7020 / GA7020S
GA7020Y
180 mm
7.2 mm
180 mm
4.0 mm
150 mm
M14 or M16 or 5/8" (country specific)
-1
8,500 min
5.6 - 7.8 kg 5.7 - 7.9 kg
Intended use
The tool is intended for grinding, sanding, wire brush-
ing, hole cutting and cutting of metal and stone materi-
als without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution
systems of between 220 V and 250 V
Switching operations of electric apparatus cause volt-
age fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.27 Ohms it can be pre-
sumed that there will be no negative effects. The mains
socket used for this device must be protected with a
fuse or protective circuit breaker having slow tripping
characteristics.
7 ENGLISH
GA7021 GA9020 /
GA9020Y
230 mm
6.5 mm
230 mm
3.2 mm
175 mm
20 mm
26 mm
-1
6,600 min
473 mm
5.6 - 7.8 kg 5.8 - 7.9 kg 5.8 - 8.0 kg
/II
GA9020S