Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
42
IGNITION
1. Open the hood of the grill before attempting to ignite the burners.
2. Set all buttons to the OFF position.
3. Connect the pressure regulator to the gas cylinder. Turn on gas supply to the
pressure regulator. Perform the leak test between the gas cylinder and the pressure
regulator.
4. Push the front left knob down. Hold
the button down while turning it
counterclockwise towards HIGH (you will
hear a click). This ignites the burner. Check
if the burner has ignited. If not, repeat the
process.
5. If the burner has not lit after trying again,
wait 5 minutes and repeat step 4.
6. Adjust the heat by turning the knob to the
High / Low position.
7.
If the burner does not work, ignite it with a
match at the ignition hole on the side of the
unit.
8. To ignite the remaining burners from left to right in sequence, repeat the step. The
adjacent burner is ignited via the ignition channel between the burners.
9. To turn the grill off, turn the valve on the gas cylinder. Then turn the knob clockwise
to the OFF position.
Attention:
If the burner does not ignite, turn the knob (clockwise). Turn the valve of
the gas cylinder until closed.
• Before using for the fi rst time, turn the grill on for 15 minutes, with the hood closed,
to the lowest fl ame. This cleans the inside of the device and makes the paint smells
evaporate.
• Clean the grill after each use. Do not use scouring agents or fl ammable cleaners, as
this may damage parts of the grill and cause a fi re. Clean with clean soapy water.
• The accessible parts of the grill can become very hot. Keep young children away at
all times (even during the cooling off period).
• Use protective gloves when handling hot parts.
Werbung
