Siemens CT918L1D0 Gebrauchsanleitung Seite 58

en Home Connect
13.2 Setting up Home Con-
nect
Requirements
The Home Connect app has been
¡
installed on your mobile device.
The appliance is receiving signals
¡
from the WLAN home network (Wi-
Fi) at its installation location.
Open the Home Connect app and
1.
scan the following QR code.
Overview of the Home Connect settings
You can find an overview of the Home Connect settings and network settings
here.
Basic setting
Home Connect
assistant
WiFi
Remote start
Software update
Note: When "WiFi" and remote start
are switched on,
the display.
58
Selection
Start
Disconnect
On
Off
On
Off
-
and appear on
Follow the instructions in the
2.
Home Connect app.
13.3 Home Connect settings
Adapt Home Connect to your needs.
You can find the Home Connect set-
tings in the basic settings for your ap-
pliance. Which settings the display
shows will depend on whether
Home Connect has been set up and
whether the appliance is connected
to your home network.
Description
Add mobile device.
Disconnect appliance from network.
Switch off the wireless module during
long absences or to save energy.
Note: In networked standby mode
your appliance requires max. 2 W.
Switch remote start on the appliance
on and off.
Note: With the Home Connect app
only switch-off is possible.
Note: This setting is only available
with a software update.
13.4 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your