Starting The Engine; Driving The Machine; Cutting Grass; Tank Filling - Gianni Ferrari GSR200 Betriebsanleitung

11.1 BRIGGS & STRATTON
REF. Description
A Ignition switch
B Basket full warning buzzer
C
PTO switch
D
Working lights switch
E
Working light
F Working light
G
Blade clutch
H Basket full micro-switch
L
Starter motor
M Engine connections
N
Bonnet closed micro-switch
N1 Left side safety micro-switch
N2 Brake alarm stop micro-switch
O Basket closed micro-switch
P Seat micro-switch

12. STARTING THE ENGINE

1) Take your place correctly on seat
2) Make sure that the parking brake in enturely engaged
3) Set engine choke control to for cold starts and turn the ignition key to the "ON" position
4) Turn the ignition key onto the symbol to start the motor
5) Slowly return choke to run position once the engine has started

13. DRIVING THE MACHINE

1) Set throttle lever.
2) Disengage the parking brake.
3) Selelect the desired speed though the pedal fitted on the right side.
4) By moving the steering wheel one steers the front wheel.
N.B.: To stop the machine, just release the forward or reverse pedal; once stopped, engage the parking brake.
IMPORTANT: To being drive at slow speed, for safety reasons make sure that people and ani-
mals are at least 3 meters away

14. CUTTING GRASS

14.1 REAR DISCHARGE OF THE GRASS
14.2 MULCHING
15. STOPPING THE ENGINE
1) Stop the machine.
2) Declutch the PDP.
3) Engage the parking brake.
4) Reduce the motor revolution on minimum.
5) Turn the ignition key from "ON" position to "STOP" position.

16. TANK FILLING

Only fill the tank in open air or in a sufficiently ventilated room. The engine must be turned off and no flames or sparks
should be made. Check that carburant is the one indicated by the label on the tank.
WARNING: CARBURANT IS HIGHLY INFLAMMABLE.
KEEP THE CARBURANT IN JERRYCANS. FILL THE TANK WITH PETROL ONLY IN OPEN AIR AND DO NOT
SMOKE DURING THIS OPERATION. ADD CARBURANT BEFORE STARTING THE ENGINE. NEVER REMOVE
THE TANK LID NOR ADD CARBURANT WHEN THE ENGINE IS WORKING OR IS HOT.
In case of carburant escape, do not try to start the engine but move the machine away from the place where the escape
took place and avoid creating ignition sources until carburant fumes have dissipated. Replace the correct lids on the
tank and the jerrycan. Never store the machine with carburant in the tank inside a building where the fumes might reach
some free flames or sparks. Let the engine cool down before storing the machine in any closed environment.
See figure 11.1
See figure 12.
See figure 13.
See figure 14.1
See figure 14.2
See figure 16.
R Hand brake micro-switch
M1_R1 Enable PTO start relay
M1_R2 PTO safety relays
M1_R3 Enable start from safety devices relay
M1_R4 Stop engine using key relay
M1_R6 PTO relay
M2_R3 Stop engine from safety devices relay
M2_R1 Stop engine from seat relay
Q
Suppressor Diode on PTO Switch
S System earth
T
Timer
V Suppressor diode on blade clutch
Y
PTO fuse
Z System protection fuse
R8
Ignition contactor switch
EN
27