Inhaltsverzeichnis
Werbung
The article you purchased was manufactured and tested at our Calflex srl facility in Nonio (VB),
Zona Industriale 5/bis- ITALY, in compliance with the quality standards UNI EN ISO 9001: 2015.
The warranty period, against any manufacturing faults or defects is 5 years (unless otherwise
stated in writing).
The parts subject to wear (mixing cartridge, head valve, non-return valve, etc ...) and the
electrical components are guaranteed for a period of 2 years.
The warranty starts from the date of purchase of the product, proven by traceable documentation
(invoice, receipt) and is not renewable.
Warranty replacement claims can only be made by presenting a dated document proving the
purchase of the product.
The warranty covers manufacturing defects only and gives the right exclusively to the repair or
to a supply of a free of charge replacement of the part identified as defective.
The defective part must be returned to Calflex s.r.l. accompanied by a report describing the
defect.
Calflex s.r.l. reserves the right to inspect the component to evaluate the warranty applicability.
The warranty does not cover defect or injured caused by: improper installation and / or use,
incorrect conception of the system, normal wear and tear, damage caused by limescale or
impurity deposits, use of cleaning and maintenance products other than those indicated in this
warranty sheet.
Calflex s.r.l. is not liable for any labour costs and / or damages, even accidental or consequential,
occurred during the installation, maintenance, or replacement of the product.
The guarantee on the surface of our products is not valid if the material has undergone a
cleaning treatment other than that suggested by Calflex. Calflex reserves the right to investigate
the nature of the damage with the help of specific laboratory tests.
For more information, please contact Calflex s.r.l. at +39 0323 889328 or your local dealer.
To clean CHROMED, VARNISHED, GALVANIC, PVD OR STAINLESS - STEEL metal parts: simply use
a damp cloth with neutral soap diluted with water and rinse. It is recommended to always dry the
metal surfaces with a soft and clean cloth to avoid the formation of limescale stains.
Important: it is recommended to use only neutral soap-based detergents diluted with water
and soft sponges / cloths. Never use abrasive detergents or disinfectants containing alcohol,
hydrochloric or phosphoric acid, bleach, chlorine or any other acid-containing product. Do not
use sharp objects or hard or scraping sponges.
Warranty
Cleaning
19
Werbung
Inhaltsverzeichnis
