Zipper Maschinen ZI-WP400TN Betriebsanleitung Seite 33

ZIPPER MASCHINEN GmbH
ZI-WP400TN
www.Zipper-Maschinen.at
9. Fixing return spring and Chain
Take the cotter pin and washer out of the guiding
pipe with spring as in Fig. I, step 1.
Move the log carriage to the base frame until the
open end of the guiding pipe is inserted into the
angle part at the base frame, as Fig. I, step 2.
Secure the pipe by using a washer and cotter pin
as shown in Fig. I, step 3.
Fix the open end of the chain to the base frame at
the left side by using a M8×50 screw, two washers
and a nut as shown in Fig. I, step 4.
Guard plate of the inner saw blade cover
Install the guard plate of the inner saw blade cover
on the saw blade guard by using a M5 nut and two
washers as shown in Fig. I, step 5.
10. Assembly limit plate
Install the limit plate and fasten it with two M5×10
screws and washers as shown in Fig. J
ASSEMBLY
33