Zipper Maschinen ZI-WP400TN Betriebsanleitung Seite 30

ZIPPER MASCHINEN GmbH
ZI-WP400TN
www.Zipper-Maschinen.at
2. Assembly handle
Attach the handle to the back of the log carriage.
Fix it with two M8×25 screws and locknuts as
shown in Fig. B. Screw the M5×20 wing screw into
the hole at the upper right corner.
3. Assembly ON-OFF switch
Fix the ON-OFF switch to the motor plate with
M4×55 screws as shown in Fig. C.
4. Assembly return spring
Fix one end of the guide pipe with return spring to
the left leg using M8×55 bolts, washers and
locknut as shown in Fig. D.
ASSEMBLY
30