Cleaning The Tool - Makita UR100D Betriebsanleitung

Cleaning the tool

with a dry cloth or one dipped in soapy water and wrung
be sure to remove it.
Fig.33: 1.
Storage
Fig.34: 1. Wire guard
Fig.35: 1. Front grip 2.
Fig.36: 1. Hole
Replacing the nylon cord
WARNING:
metal wire, rope or the like. Use recommended nylon cord only, otherwise it may cause damage to the tool and
WARNING:
Make sure that the cover of the nylon cutting head is secured to the housing properly as
described below.
Fig.38: (1) Up to 8 m (2) 70 - 80 mm
Replacing the plastic blade
blade with the mark on the plastic blade head, and then
insert it all the way until it locks in place with a little click.
procedure in reverse.
Fig.37: 1. Blade 2.
NOTE:
increases when the machine is operated with no-load.
16 ENGLISH