Parts Description - Makita DVP181ZK Bedienungsanleitung

Wear safety glasses and gloves when handling
4.
refrigerant; avoid contact with refrigerant,
blindness and injuries may result to operator.
Adequate performance may not be obtained in
5.
extremely hot or cold environments.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product.
MISUSE or failure to follow the safety rules stated
in this instruction manual may cause serious
personal injury.
Important safety instructions for
battery cartridge
1. Before using
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product
using battery.
2. Do not disassemble battery cartridge.
If operating time has become excessively
3.
shorter, stop operating immediately. It may
result in a risk of overheating, possible burns
and even an explosion.
If electrolyte gets into your eyes, rinse them out
4.
with clear water and seek medical attention right
away. It may result in loss of your eyesight.
Do not short the battery cartridge:
5.
(1) Do not touch the terminals with any
conductive material.
(2) Avoid storing battery cartridge in a
container with other metal objects such as
nails, coins, etc.
(3) Do not expose battery cartridge to water or
rain.
A battery short can cause a large current
flow, overheating, possible burns and even a
breakdown.
6. Do not store and use the tool and battery
cartridge in locations where the temperature
may reach or exceed 50°C (122°F).
7. Do not incinerate the battery cartridge even if it
is severely damaged or is completely worn out.
The battery cartridge can explode in a fire.
8. Be careful not to drop or strike battery.
9. Do not use a damaged battery.
10. Follow your local regulations relating to
disposal of battery.
11. The contained lithium-ion batteries are subject to
the Dangerous Goods Legislation requirements.
When disposing the battery cartridge, remove it
from the tool and dispose of it in a safe place. Follow
your local regulations relating to disposal of battery.
12. Use the batteries only with the products
specified by Makita.
13. If the tool is not used for a long period of time,
the battery must be removed from the tool.
14. During and after use, the battery cartridge may
take on heat which can cause burns or low
temperature burns.
battery cartridge, read
15. Do not touch the terminal of the tool immediately
after use as it may get hot enough to cause
burns.
16. Do not allow chips, dust, or soil stuck into the
terminals, holes, and grooves of the battery
cartridge. It may result in poor performance or
breakdown of the tool or battery cartridge.
17. Unless the tool supports the use near a high-
voltage electrical power lines, do not use the
battery cartridge near a high-voltage electrical
power lines.
18. Keep the battery away from children.
SAVE THESE INSTRUCTIONS.
CAUTION:
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing fires, personal injury and damage. It will also
all
void the Makita warranty for the Makita tool and charger.
Tips for maintaining maximum
battery life
Charge the battery cartridge before completely
1.
discharged. Always stop tool operation and
charge the battery cartridge when you notice
less tool power.
2. Never recharge a fully charged battery cartridge.
Overcharging shortens the battery service life.
Charge the
3.
temperature at 10°C - 40°C (50°F - 104°F). Let a
hot battery cartridge cool down before charging
it.
When not using the battery cartridge, remove it
4.
from the tool or the charger.
5. Charge the battery cartridge if you do not use it
for a long period (more than six months).

PARTS DESCRIPTION

► Fig.1:
1. Intake port 3/8"
2. Gas ballast valve
3. Oil fill/Exhaust cap
4. Intake port 5/16"
5. Sight glass
6. Drain valve
7. Oil tank
8. Area around pump
9. Solenoid valve
10. Base
11. Motor
7 ENGLISH
Only use genuine Makita batteries.
battery cartridge
12. LED lamp
13. Power switch
14. Battery guard
15. Battery holder
16. Battery (on the Left
port)
17. Battery (on the Right
port)
18. Handle
19. Wiring cover
with room