Trouble Shooting; Spare Parts List Content; Possible Cause - FMS 1280mm Easy Trainer V2 Bedienungsanleitung

Trouble shooting

Problem
Aircraft will not respond to
the throttlebut responds to
other controls.
Extra propeller noise or
extra vibration.
Reduced flight time or
aircraft underpowered.
Control surface does not
move, or is slow to respond
to control inputs.
Controls reversed.
-Motor loses power
-Motor power pulses then
motor loses power.
LED on receiver flashes
slowly.

Spare parts list content

FMSSQ101-1 Fuselage
FMSSQ102-1 Main Wing
FMSSQ103-1 Horizontal Stabilizer
FMSSQ104-1 Canopy
FMSSQ107-1 Linkage Rods
FMSSQ109 Sticker
FMSSQ115 Pipe
FMSPROP043 Propeller
FMSDJ020 Motor Mount
FMSBM043 Motor Board
PRKV2650-S Motor
PRESC004 ESC
FMS9GDP 9g Servo
FMSCHR01 Charger
Visit our website: www.fmsmodel.com to see photo of this product. Enter the key word "ESC" in the search bar for the
stock ESC instruction manual.

Possible Cause

-ESC is not armed.
-Throttle channel is reversed.
-Damaged spinner, propeller,
motor or motor mount.
-Loose propeller and spinner parts.
-Propellor installed backwards.
-Flight battery charge is low.
-propeller installed backward.
-Flight battery damaged.
-Control surface, control horn,
linkage or servo damage.
-Wire damaged or connections
loose.
Channels are reversed in the
transmitter.
-Damage to motor, or battery.
-Loss of power to aircraft.
-ESC uses default soft Low Voltage
Cutoff(LVC).
Power loss to receiver.
-Lower throttle stick and throttle trim to lowest settings.
-Reverse throttle channel on transmitter.
-Replace damaged parts.
-Tighten parts for propeller adapter, propeller and spinner.
-Remove and install propeller correctly.
-Completely recharge flight battery.
-Replace flight battery and follow flight battery
instructions.
-Replace or repair damaged parts and adjust controls.
-Do a check of connections for loose wiring.
Do the control direction test and adjust controls for
aircraft and transmitter.
-Do a check of batteries, transmitter, receiver, ESC, motor
and wiring for damage(replace as needed).
-Land aircraft immediately and recharge flight battery.
-Check connection from ESC to receiver.
-Check servos for damage.
-Check linkages for binding.
10
Solution
E
N