Maintenance And Care (System) - Flyer PINION E-DRIVE SYSTEM Benutzerhandbuch

MAINTENANCE AND CARE (SYSTEM)

ATTENTION
Damage to components due to moisture penetration.
→ Only use or clean the electrical components (E‑Trigger,
MGU wiring harness, etc.) when cable plugs or plug
caps are connected.
→ Do not use high-pressure or steam cleaners for
cleaning.
→ Only clean the system components when they are
assembled and connected.
→ Clean the components only with water and neutral
soap.
→ Check before and after the ride whether the e-bike battery
is sufficiently charged.
IMPORTANT
In order to carry out the gearbox oil change as per the
maintenance plan, the MGU must be professionally serviced.
Your specialist dealer is the right partner here.
WHEN DO I HAVE TO GO TO THE DEALER?
● When changing to a tyre with significantly different
dimensions. Otherwise, an incorrect speed will be shown
on your display. Accordingly, the legally prescribed
maximum assisted speed (25/45 km/h) is also shifted.
● If the number of teeth of the rear belt wheel/sprocket is
changed (hacker protection triggers)
● To change the oil every 10,000 km.
● For an update of the system.
67