Connecting Usb Devices - Makita DCX200 Betriebsanleitung

Battery BL1055B
While the battery BL1055B is unplugged, press the
power button. The battery capacity indicator lights up
for a few seconds.
► Fig.12: 1. Power button 2. Battery capacity indicator
Meaning of the indicator lamp
Indicator lamps
Lighted Off
Battery protection system
If the remaining battery capacity is too low, the device
will not operate. When you turn the device on, the
power is supplied to the heating parts again, but stops
soon. In this situation, remove and recharge the battery
cartridge.

Connecting USB devices

CAUTION:
Connect only devices that are
compatible with the USB power supply port. Not
doing so may cause a malfunction.
NOTICE:
Before connecting a USB device,
always back up the data on the USB device. Not
doing so may cause a loss of your data.
NOTICE:
The battery holder and Battery
BL1055B may not supply power to some USB
devices.
NOTICE:
When not using or after charging,
remove the USB cable and close the cover.
NOTE: The actual output current varies depending on
the USB device to be connected.
NOTE: Battery power is consumed while the power
button is turned on. Always turn off the switch when
not in use.
NOTE: When charging multiple USB devices in suc-
cession, wait about 10 seconds after charging of the
previous device has completed before beginning to
charge the next device.
The battery holder (with the battery) and Battery
BL1055B can work as an external power supply for
USB devices.
1. Open the cover and connect a USB cable (not
included) to the USB port. Then connect the other
end of the cable to the device.
2.
Start charging:
Remaining
capacity
Blinking
50% to 100%
25% to 50%
10% to 25%
Less than
10%
Battery
abnormality
— When using battery holder (with the battery), press
and hold the power button until the power level
indicator lights up. The battery supplies DC 5 V,
2.4 A.
Battery holder (with battery)
► Fig.13: 1. Power button 2. USB port
— When using Battery BL1055B, press the power
button. The battery supplies DC 5 V, 1.5 A.
Battery BL1055B
► Fig.14: 1. Power button 2. USB port
MAINTENANCE
CAUTION:
Always be sure that the base layer
shirt is switched off and the battery cartridge is
removed before attempting to perform inspec-
tions or maintenance.
CAUTION:
If the base layer shirt does not
switch on or any fault is found with a fully
charged battery cartridge, clean the terminals of
the battery holder and the battery cartridge. If the
base layer shirt still does not work properly, stop
using the base layer shirt and contact our autho-
rized service center.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Cleaning the base layer shirt
• Detach the battery and the battery holder from the
base layer shirt before washing.
• Follow the instructions on the tag.
• Do not wash the base layer shirt with other
clothes. Doing so may cause color fading or color
transfer.
• Use a laundry net when using a washing machine.
• Do not use the fabric softener.
• Use only neutral detergent.
• After washing, take out the base layer shirt from
washing machine at once.
• Be sure to put the plug in the battery pocket and
close the zip fastener before washing.
11 ENGLISH