Functional Description - Makita DCX200 Betriebsanleitung

To remove the battery cartridge, slide it from the battery
holder while pressing the button on the front of the
cartridge.
► Fig.4: 1. Red indicator 2. Button 3. Battery cartridge
4. Battery holder
CAUTION:
Always install the battery car-
tridge fully until the red indicator cannot be seen.
Otherwise the battery cartridge may accidentally
fall out of the battery holder, causing injury to you or
someone around you.
CAUTION:
Do not forcibly install the battery
cartridge. If the battery cartridge does not slide in
easily, it is not being inserted correctly.
Battery pocket
The battery can be stored in the battery pocket.
Connect the plug of power cable to the battery. Then
put the battery into the battery pocket and fasten the
fastener.
► Fig.5: 1. Power cable 2. Plug 3. Battery pocket
NOTE: The battery holder (with battery cartridge)
cannot be stored in the battery pocket.
Attaching the battery holder
You can hang the battery holder on your waist belt.
To prevent the battery holder from dropping acciden-
tally, attach a strap using the strap hole and secure it.
1. Feed the plug through the hole in the battery
pocket and pull it through to the inside of the base
layer shirt.
► Fig.6: 1. Power cable 2. Hole 3. Battery pocket
4. Plug
2.
Attach the belt hook of the battery holder to your
waist belt. Connect the plug of the power cable to
the battery holder.
► Fig.7: 1. Belt hook 2. Battery holder 3. Waist belt
4. Power cable
The battery holder has an anti-drop function. When
removing the battery holder from the belt, pull up the
battery holder while pressing the unlock button.
► Fig.8: 1. Unlock button
FUNCTIONAL
DESCRIPTION
Power button
To turn on the base layer shirt, connect all the cables,
press and hold the power button on the battery or bat-
tery holder. To turn off, press and hold the power button
on the base layer shirt.
NOTE: The power level indicator on the battery
holder is not used with the base layer shirt. Only the
power level indicator 4 will light up when using the
base layer shirt.
► Fig.9: 1. Power button 2. Power level indicator
NOTE: The battery and the battery holder automat-
ically turns off approximately 1 hour after the base
layer shirt is turned off.
Temperature adjustment
CAUTION:
For continuous operation, set the
temperature setting to "low" (blue). If the base
layer shirt is overheated, the base layer shirt may
cause a malfunction and cause an injury.
There are three temperature settings (high, medium,
low). When you switch on the base layer shirt, the tem-
perature is set to "low". Each time you press the power
button, the temperature setting changes as shown in
the figure. The color of the power button shows the
current setting.
► Fig.10: 1. Blue: "low" 2. Red: "high"
3. White: "medium"
Indicating the remaining battery
capacity
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Only when using the battery cartridge (with the
indicator) used with battery holder
Press the check button. The indicator lamps light up for
a few seconds.
► Fig.11: 1. Indicator lamp 2. Check button
Meaning of the indicator lamp
Indicator lamps
Lighted
(For LXT batteries only)
(For LXT batteries only)
NOTE: For LXT batteries only:
The first (far left) indicator lamp will blink when the
battery protection system works.
10 ENGLISH
Off Blinking
malfunctioned.
Remaining
capacity
75% to 100%
50% to 75%
25% to 50%
Less than
25%
Charge the
battery.
The battery
may have