Sharp KH-7IX19FS00-EU Bedienungsanleitung Seite 38

The above image shows the front right
heater display indicating the boiling
function.
Frying Function
This function will fry oil at around 160°C.
To activate this function, press the heater
selection button three times. When the
frying function has been activated, the
corresponding display will show 'F'.The hob
will beep when the oil is ready for frying.
In the above image, the front right heater
display is indicating the frying function.
Keep-Warm Function
This function allows the temperature of
food to be kept at around 50°C. To activate
the keep-warm function, press the heater
selection button four times. When the
keep-warm function has been activated, the
corresponding display will show 'u'.
The image above shows the front right
heater display indicating the keep-warm
function.
Chocolate-Melting Function
This function melts chocolate or similar
foods at around 40°C. To activate the
chocolate-melting function, press the
heater selection button five times. When
the chocolate-melting function has been
activated, the corresponding display will
show 'c'.
The image above shows the front right
heater display indicating the chocolate-
melting function.
Performance and time may vary
according to the quantity of food in the
pan and the quality of the pan. 1.5
litres of water or 0.5 litres of oil gives the
best cooking performance with these
functions.
If there is an error, an error code will be shown on the
E1 Cooling Fan is disabled. Call an authorised
E3 Supply voltage is other than the rated values.
Switch the hob off by pressing
"H" disappears for all zones, switch the hob
on by pressing
the same error is displayed again, call an
E4 Supply frequency is different from the rated
values. Switch the hob off by pressing
zones, switch the hob on by pressing
and continue to use. If the same error is
displayed again, switch the plug for the
appliance off and on. Switch the hob on by
pressing
error is displayed again, call an authorised
E5
Internal temperature of the hob is too high,
switch the hob off by pressing
E6 Communication error between the touch
control and heater. Call an authorised service
E7 Coil temperature sensor is disabled. Call an
E8
Cooler temperature sensor is disabled. Call
EN - 17
Error Codes
heater displays.
service agent.
and continue to use. If
authorised service agent.
, wait until "H" disappears from all
and continue to use. If the same
service agent.
heaters cool down.
agent.
authorized service agent.
an authorized service agent.
,wait until
and let the