Charging The Powerpack - APA 16444 Bedienungsanleitung

6. OPERATING INSTRUCTIONS
6.1 OVERVIEW
1 Switch
2 Display
3 Inductive charger
4 USB-C input
5 USB2 output
6 USB3 output
7 LED light
8 EC5 starting help
connection
6.2 CHECKING THE CHARGING LEVEL OF
THE POWERPACK
Press the switch once (position 1 in the overview). The
display (position 2 in the overview) is activated and
shows the charging status of the Powerpack in percent
(position 14 in the overvie.

6.3 CHARGING THE POWERPACK

To charge the Powerpack, use a USB charger with 2 A
output (do not include in the scope of delivery!). Insert
the USB-C plug of the charging cable (position 12 in the
overview) into the USB-C input (position 4 in the over-
Figure 1: Overview Figure 1: Overview
9 Terminal clamp, black (-)
10 Terminal clamp, red (+)
11 Smartbox jump lead
12 USB-C charging cable
13 Bag
14 Charging level in %
15 Display input-output
16 USB2-Output active1
17 USB3-Output active
view) of the powerpack. Insert the USB-A plug of the
charging cable into the charger. Connect the charger to
a power socket.
The display shows the charging progress in percent,1%
- 99%. At 100%, the Powerpack battery is fully charged.
After charging, first unplug the charger from the socket
and then disconnect the charging cable from the charger
and the Powerpack.
6.4 JUMP START FOR 12 V VEHICLES
1. Switch off the ignition and all consumers on your
vehicle.
2. Ensure that the battery capacity of the Powerpack is
still at least 75% and that the battery callipers of your
vehicle battery are not soiled or oxidised..
3. Connect the powerpack and the jumper cable by in-
serting the plug of the start box (position 11 in the
overview) of the jumper cable into the jumper con-
nector (position 8 in the overview) of the powerpack.
When doing so, make sure that the plug is firmly and
securely inserted. The indicator lights (18 and 19) of
the jumper box flash alternately.
4. First connect the red pole clamp (position 9 in the
overview) of the jump-start cable to the positive pole
and then the black pole clamp (position 10 in the
overview) to the negative pole of the vehicle battery.
The pole clamps must have a firm and secure contact
to the battery poles. If the polarity of the cables is
reversed or if there is a short circuit, the red indicator
light (19) of the jumper box lights up and a warning
tone sounds. If the jumper cables are connected cor-
rectly, the green control light (18) lights up and a click
sound is emitted for approx. 20 sec.
5. Start the engine of your vehicle within these 20 sec.
After the 20 sec. have elapsed, the click sound stops
and the red indicator light lights up. A start attempt is
now no longer possible. For a new start attempt, you
must now disconnect the start box from the Power-
pack and remove the pole clamps from the battery.
Start again from point 3 of this section.
6. Do not let the starter motor operate for more than 3
seconds. If the start attempt was not successful, dis-
connect the start box from the Powerpack, remove
the terminal clamps from the battery and wait at least
9