Installation Instructions; Before Using This Appliance; Wine Cellar Installation - La Sommeliere ECELLAR150 Gebrauchsanweisung

4. INSTALLATION INSTRUCTIONS

Before using this appliance

•
Remove the outer and inner packaging.
•
Leave your device in an upright position at rest for about 24 hours before putting it into service. This will
reduce the possibility of cooling system malfunction due to transportation.
•
Clean the inside with a soft cloth and lukewarm water.
•
When installing your device, please choose an authorized location.
•
Place your device on a floor that is strong enough to support it when fully loaded.
•
Place your cellar on a floor that is strong enough to support it when fully loaded.
•
Please adjust the feet of your appliance in order to level your cellar. Warning ! your cellar should be
tilted slightly backwards to ensure good drainage of condensation water and a good seal on the door
seal. This inclination will also keeps the drawers or shelves in place despite the weight of the bottles.
Adequate ventilation is necessary, do not obstruct any air outlet.
•
This appliance is intended for freestanding installation. It must in no case be built-in or
integrated. Good air circulation around your device must be observed.
•
Connect the cellar to a single outlet, leave a space of 50mm between the back of the cellar and the wall
and 100mm on each side and above your device. Make sure to wedge it perfectly and adjust the
horizontality of your wine cellar (the use of a spirit level is recommended). Warning ! your cellar should
be tilted slightly backwards ; this will prevent any movement due to instability, which generates noise
and vibration, and will ensure the door is completely airtight.
•
This device is only used for storing wines.
•
This appliance uses flammable refrigerant gas, so please never damage the cooling pipe during
transportation.
Attention
• Store wine in sealed bottles.
• Do not overload the cabinet.
• Do not open the door unless necessary.
• Do not cover shelves with aluminum foil or any other shelf material which may prevent air
circulation.
• Should the wine cooler be left empty for long periods it is suggested that the appliance is
unplugged, and after careful cleaning, leave the door ajar to allow air to circulate inside the cabinet
in order to avoid possible condensation, mold or smell.
CAUTION: please keep the appliance away from substance, which can cause ignition.

Wine Cellar Installation

Warning! To prevent the wine cellar from tipping over, it is important to load the rear bottle
positions first. The shelves must not be pulled out or left out at the same time. The weight
of the bottles can cause the cellar to tip forwards, it is essential to distribute the weight of
the bottles throughout the cellar and to handle it with care.
53