Location; Handle Installation - La Sommeliere ECELLAR150 Gebrauchsanweisung

Power supply
Connect the wine cellar to a single, wall-mounted type E socket.
The cellar must be plugged into a single, easily accessible socket.
All questions relating to power and / or earthing must be handled by qualified personnel (electrician,
authorized service).

Location

•
Warning ! The cellar must be placed in a clean environment (not dusty), frost-free, away from
a heat source, type: radiator, oven, sunlight, etc ... it must not be installed outdoors.
• Place the cellar in a location strong enough to support the full load weight.
• To level it adjust the height of the adjustable feet below the cellar.
This device is suitable for operation in rooms with a very specific ambient temperature, this climatic
class is indicated on the rating label.
When selecting a location for your appliance you should make sure the floor is flat and firm, and the
room is well ventilated. This device is suitable for operation in rooms with a very specific ambient
temperature, this climatic class is indicated on the nameplate. The ambient temperature affects the
interior temperature and humidity of your cellar. For optimal operation, your cellar settings are made
for ambient temperatures of 23 ° C to 25 ° C.
The temperature of the device is adjustable between 5°C to 20°C. The temperature is regulated by a
thermostat. Changing the temperature generates higher energy consumption.
The device ensures that the temperature is maintained as long as it is in operation and is used under
normal conditions of use. The temperature inside the appliance and its energy consumption can be
influenced by many factors: ambient temperature, exposure to the sun, number of door openings and
quantity stored... Slight changes in temperature are perfectly normal and correspond to cooling cycles
of the device. But these variations in no way affect the storage temperature of the wines, these
variations being too short for heat exchange with the bottles.

Handle installation

When fitting the handle of your cellar, proceed carefully so as
not to break the glass of the door. Install the handle only with
a manual screwdriver. Do not use power tools that could
break the glass. Gently tighten the screws starting with the
top one, do not tighten it all the way. Then install the bottom
screw, once the 2 screws are positioned, adjust the
tightening to fix the handle correctly, but without screwing too
hard.
CAUTION do not tighten to the limit. Over-screwing can
break the glass.
•
Remove the handle and its two screws from the plastic bag inside the cellar.
•
Before installing the handle, you must remove the door seal on a part. This does not affect
the seal of the gasket if you take care to remove it correctly.
•
Peel off the seal from the corner of the door to the necessary level then insert the two screws
into the handle holes.
•
Screw the handle and put the gasket back into the slot in the door to finish with the corner.
54