Cleaning, Maintenance And Ordering Of Spare Parts; Ordering Replacement Parts; Disposal And Recycling - EINHELL 34.310.30 Originalbetriebsanleitung

Anleitung_BG_RT_1340_M_SPK7__ 25.07.12 09:23 Seite 13
8. Cleaning, maintenance and ordering
of spare parts
Maintenance and cleaning work on the machine as
well as removal of the safety devices may only be
performed when the motor is switched off and the
power cable has been pulled.
8.1 Cleaning
Keep all safety devices, air vents and the motor
n
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
n
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
n
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
8.2 Replace the hoe blades
For safety reasons, we recommend having the hoe
blades replaced by an authorized professional (see
address on warranty certificate).
Important!
Wear working gloves. Use only genuine spare parts
since otherwise the function and safety of the
machine cannot be guaranteed.
8.3 Maintenance
Ensure that all mounting components (i.e. screws,
bolts, nuts etc.) are always tightened so that the
machine can be safely operated at all times.
Store the device in a dry room. All the metal parts
should be cleaned and then oil to ensure that they
provide a long life. For best results, clean the plastic
parts of the machine with a brush or rag. Do not use
any solvents to remove dirt.
For space saving storage undo the star nuts (Fig.
5/Item 8) and fold the bottom push bar (Fig. 5/Item 1)
forward. Ensure that you do not damage the cable.
At the end of the season, perform a general
inspection of the machine and remove any deposits
which may have accumulated. At the start of each
season, ensure that you check the condition of the
machine. If repairs are necessary, please contact
one of our customer service centers (see address on
warranty certificate).

8.4 Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
n
Article number of the machine
n
Identification number of the machine
n
Replacement part number of the part required
n
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
10. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
GB
13